Wi-fi Internet Radio Sagem Rm50. Remove the old glass. Use a utility knife to slice off the outer edge of the seal, running a thin blade between the glass and the seal. Pull out the glass and chuck the old seal. As you cut away the old seal make sure not to let the window fall out. • Use this step as well if you are removing the glass yourself at the junkyard. Use duct tape to hold the glass to the car body by running 2 vertical pieces of duct tapes to the roof and the center of the glass. Should the glass 'pop out' when you cut the last old seal you will have time to catch it.
Prepare the seal and window or windshield to go back on the bus. Get some nylon rope a little thinner than a pencil and long enough to go all the way around the window with enough left over to hold on to - about 6 inches (15.2 cm) to a foot on either side. • Again, soapy water can help here: Starting at the bottom of the window and leaving some excess rope hanging out, begin inserting the rope into the groove in the rubber seal that will seat into the window frame on the bus. • Run the rope all the way around the window seal in the groove and leave the excess dangling from the bottom. Keep the whole mess in line with some electricians tape. It is less adhesive than duct tape and will be easier to remove when all is in position.
Is a short tip on installing pop-out window seals into your vintage VW. Here we have a pair of New Old Stock popout windows for a 1967 VW beetle. It’s time to install the. VW Popout Window Seal Replacement; 1967 VW Beetle.
Lube the window frame with soapy water,and have someone outside the vehicle press the new glass and seal up against the frame with the bits of rope hanging on the inside of the bus. • Line up the glass (This is especially important with bay window-style windshields, because the curved glass has to fit the frame just right.), then have the person outside the vehicle press the glass firmly into place. Set the bottom part of the seal in the frame first as it is the hardest part to get right. Ancillary Files Stata Download. • The second person on the inside needs to grasp the rope and begin pulling inward. That should pull the inner lip of the rubber seal over the edge of the window frame and begin seating the window to the vehicle.
As you pull the rope towards you inside the van, the window should suck into place. Use a silicone spray lube to soften and slip the seal into position • Make sure the person outside continues to apply firm pressure and keep everything lined up as the person on the inside pulls the rope towards them. Again, there are special tools that do the same thing, but rope works well and is just about free. • Have a thin putty knife without sharp edges on hand to help with any trouble spots or snags the rope may hit.